Adjusting Stand-Up Angle - Invacare Dragon Vertic User Manual

1. Loosen the screws A that allows the support pads to
slide forwards and backwards.
2. Adjust the supports to the desired position.
3. Re-tighten the screws.

5.11 Adjusting stand-up angle

The verticalizer could be destroyed if the position
of the upper shut-off switches is changed
– Never modify the position of the upper shut-off
switches.
• Flat screwdriver, width of edge approx. 6 mm
The control box (1) for the limit stop of the verticalizer is
located under the seat.
1451170-L
1. Raise verticalizer.
2.
Carefully release rubber cover at upper end of control
box and remove.
3.
There are three limit switches in the control box, two
at the upper end and one at the lower end. The lower
limit switch (1) is the one used to adjust the stand-up
angle. Never change the position of the upper shut-off
switches.
Setup
41