Installing/Adjusting Optional Clamp On Raised Footrest; Installing; Adjusting; Replacing/Adjusting Optional Adjustable Angle Footrest - Invacare Top End Crossfire T6 Owner's Operator And Maintenance Manual

SECTION 4—FOOTREST

Installing/Adjusting Optional Clamp on Raised Footrest

NOTE: For this procedure, refer to FIGURE 4.2.

Installing

1. Install the two half clamps onto either
side of the wheelchair frame
approximately 2-inches above existing
footrest with two provided allen
screws.
2. Repeat for the opposite side of the
wheelchair.
3. Slide the clamp on raised footrest into
the half clamps to the desired height.
4. Securely tighten the four allen screws.

Adjusting

1. Loosen the four allen screws.
2. Adjust clamp on raised footrest to the desired height.
3. Securely tighten the four allen screws.
Replacing/Adjusting Optional Adjustable Angle
Footrest
NOTE: For this procedure, refer to FIGURE 4.3.

Replacing the Footrest

1. Loosen, but DO NOT the allen screw of the two clamps that secure the footrest to the
wheelchair frame.
2. Slide the existing footrest tubes out of the wheelchair frame and install new footrest
by reversing this step.
3. Position the new footrest to a determined height.
4. Tighten the allen screw of the two clamps that secure the footrest to the wheelchair
frame.
5. Adjust the footplate to the desired position. Refer to Adjusting Footplate Angle on
page 29 and/or Adjusting Footplate Depth on page 29.
™
Crossfire Series Wheelchairs
Wheelchair Frame
Half Clamp
Raised
Footrest
FIGURE 4.2 Installing/Adjusting Optional
Clamp on Raised Footrest
28
Allen
Screws
Outside
Footrest
Hoop
Part No 1134872