Table of Contents
Advertisement
GAS TAPS
Do not let cleaning products come into contact with the valves.
•
Periodic lubrication of the gas taps must be carried out by specialist personnel only.
•
In the event of operating faults in the gas taps, call the Service Department.
•
CONTROL KNOB
The control knobs may be removed for cleaning but care should be taken not to damage the seal.
BURNERS AND GRIDS
These parts must be cleaned using a sponge and soapy water or other suitable non-abrasive
products. Dry with a soft cloth.
Warning! Not dishwasher safe.
After cleaning, the burners and their flame spreaders must be well dried and correctly re-
placed.
It is very important to check that the burner flame spreader and the cap have been correctly
positioned. Failure to do so can cause serious problems.
Check that the electrode/s "S" (figs. 10, 12) next to each burner is/are always clean to ensure trou-
ble-free sparking.
Check that the probe/s "T" (figs. 10, 12) next to each burner is/are always clean to ensure correct
operation of the safety valves.
Both the probe and ignition plug must be very carefully cleaned.
Note: To avoid damage to the electric ignition do not use it when the burners are not in
place.
Note: Continuous use may cause a change in the glaze around the burners and grids, cor-
responding to the areas exposed to the heat. This is a natural phenomenon and does not
prevent the parts from working properly.
CORRECT REPLACEMENT OF THE
It is very important to check that the burner flame distributor "F" and the cap "C" have been cor-
rectly positioned (see figs. 10, 11) - failure to do so can cause serious problems.
CORRECT REPLACEMENT OF THE TRIPLE-RING BURNER
The burner must be correctly positioned; failure to do so can cause serious problems.
Fit the flame spreader to the housing as shown by the arrows (see figs. 12).
The burner correctly positioned must not rotate (fig. 13).
Then position the cap "A" and the ring "B" (figs. 13, 14).
SEMI-RAPID BURNER and RAPID
AUXILIARY ,
25
Advertisement
Table of Contents
