Fastening the Installation Brackets
•
Each hob is provided with an installation kit including brackets and screws for fastening the
top to fixture panels from 2 to 4 cm thick.
•
Turn the hob upside down and fasten the brackets "A" to the appropriate socket holes,
without tightening the screws "B" for the moment (fig. 5).
•
Make sure that the brackets are fastened as shown in figure 4.
Fastening the Hob
•
Spread the sealing material "C" out along the fixture hole, making sure that the junctions
overlap at the corners.
•
Insert the hob into the hole and position it correctly.
•
Adjust the position of the brackets "A" and tighten screws "B" to block the hob firmly in
position.
•
With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the
hob. Take care not to damage the benchtop.
10
(fig. 4)
(fig. 5)
A
Fig. 4
A
A
A
B
Fig. 5
A
A
C
A