Rack Mounting - Sony DNW-A75 Maintenance Manual

1-6. Rack Mounting

1-6. Rack Mounting
Explains how to mount this unit into a 19-inch standard
rack.
Be sure to mount this unit into a rack accurately following
the procedure and notes mentioned below.
c
. Use the specified rack mount rail.
The use of other rail of low-strength may drop the unit
and cause the risk of injury.
. To prevent toppling over the rack, fix it on the horizontal
and firm floor securely with bolts, etc.
. Mounts the unit into a rack with a steady posture.
n
. When other equipment with built-in hard disk drive are
already mounted in the same rack for mounting this unit,
turn off the power of the equipment before mounting this
unit.
. Connect long enough cables on the connector panel,
considering that the unit is pulled out from the rack.
. Do not operate this unit without the upper lid and bottom
plate except when servicing it.
. To reduce an increase in the internal temperature of this
unit, leave a space on the top or bottom of this unit by
1U.
. Adjust the temperature inside the rack within the range
of the unit's operating temperature.
Specified Rack Mount Kit
RMM-111 (Optional accessory) or
RMM-110 (Optional accessory)
The color of rack angle of RMM-111 fits to the unit.
RMM-110 is the same consistance, strength and dimension
as RMM-111, but the color of rack angle is different.
n
To mount this unit in the FLEXICART, it is recommended
to use the BKFC-53/2.
1-4
Parts Packed in RMM-110/111
. Slide rails ......................................... 2
. Rack angles (handles) ..................... 2
. Rail brackets .................................... 4
. Plate nuts (large) ............................. 4
. Plate nuts (small) ............................. 4
. Screws (PSW4 x 16) ...................... 4
. Screws (B4 x 8) .............................. 8
. Hexagon socket head cap screws .... 8
. Flat washers ..................................... 8
. Screws (RK5 x 14) ......................... 2
. Ornamental washers ........................ 2
. L-shaped hexagon wrench............... 1
DNW-A75/A75P