Rack Mounting - Sony BETACAM SX DNW-A30 Maintenance Manual

1-6. Rack Mounting

1-6. Rack Mounting
Explains how to mount this unit in a 19-inch standard rack.
Install this unit in a rack accurately as following procedure
using specified rack mount rail.
If not, there is a fear of unexpected accident such as a drop
of the unit or turnover of the rack.
Specified Rack Mount Kit
RMM-111 (Option) or
RMM-110 (Option)
c
Use the specified rack mount rail.
If not, injury could occur by drop of the unit because
strength of rail is not enough.
n
The color of rack angle of RMM-111 fits to the unit.
RMM-110 is the same consistance, strength and dimension
as RMM-111, but the color of rack angle is different.
Parts Packed in RMM-110/111
. Slide rail .......................................... 2
. Rack angle (handle)......................... 2
. Rail bracket ..................................... 4
. Plate nut (large) ............................... 4
. Plate nut (small) .............................. 4
. Screw (PSW4 x 16) ........................ 4
. Screw (B4 x 8) ................................ 8
. Hexagon socket head cap screw ...... 8
. Flat washer ...................................... 8
. Screw (RK5 x 14) ........................... 2
. Ornamental washer.......................... 2
. L-shaped hexagon wrench............... 1
Notes on Rack Mounting
. Adjust so that the temperature inside the rack is in the
range of the unit's operating temperature.
. To prevent turning over the rack, fix the rack on the
horizonal and firm floor securly using the bolts.
. Never remove the upper lid, bottom plate, and so on
during rack mounting.
. Connect long enough cables on the connector panel,
considering that the unit is pulled out from the rack.
1-4
Rack Mounting Procedure
. Remove of feet
(1) Place the unit on its right side panel down.
n
Lend your hand so that the lower handle does not hang
down.
(2) Unscrew the four screws and remove the feet from the
bottom plate of the unit.
(3) Replace the unit to the horizonal position.
Foot
Foot
c
Keep these screws and the feet that are removed in this
procedure carefully.
Tighting torque: 1.0 N . m {10 kgf . cm}
PS4 x 14
PS4 x 14
DNW-A30/A30P
DNW-30/30P