Table of Contents
Advertisement
Table 5-1. Normal Mode of Operation
RTS
Signal V.54 Loop-
CTS
Follows
OFF
DCD
—
—
DSR
—
OFF
Where "—" = don't care
*Until backup becomes active
0.2 D rop Port Configuration (Port Config) Menu Items
The menu items are:
Menu Item
NFAS Word NFAS Word. If enabled, the network interface receiver
CAS/TS16
CRC-4
61200420L1-1
511 TST
back
ON
OFF
—
OFF
requires the NFAS word (TS0) in odd frames) and the
FAS word (TS0 in even frames) for frame sync. When
disabled, only the FAS word is needed for frame sync.
Choices: Enable, Disable
Enables/Disables Channel Associated signalling time
slot 16 multiframing). When this menu option is
enabled, the following occurs:
1. The TS16 multiframe alignment signal is inserted in
the outgoing data stream (toward the PBX).
2. Signaling Bits are transmitted in TS 16.
3. The TS16 multiframe alignment signal must be
received for frame sync.
If CAS/TS16 is enabled on the Drop Port, it must
also be enabled on the Network Interface.
When this option is enabled, the CRC-4 checksum bits
are transmitted in the outgoing data stream toward PBX.
Also, the received signal is checked for errors.
Choices: Enable, Disable
ESU 120e User Manual
Chapter 5. Configuration Menu
Self Test
Netwk Test
Active
Active
OFF
OFF
OFF
—
OFF
OFF
Description
No DS0
Network
Mapped
Alarm
OFF
OFF
OFF
OFF
OFF
—
5-19
Advertisement
Table of Contents
