Table of Contents
Advertisement
To set up the ESU 120e to work with T-Watch PRO over the LAN,
follow these steps:
Step
1
2
3
4
To set up the ESU 120e to work with T-Watch PRO over a direct
EIA-232 connection, the following steps are required:
Step
1
2
3
4
61200420L1-1
Set the Unit ID using the Front Panel. See Unit ID on
page page 6-4 for details.
Set TCP/IP interface to 10BaseT (or SLIP) using the
Front Panel.
Configure the IP address, default gateway, and subnet
mask using the Front Panel.
Follow the installation instructions for T-Watch PRO to
start the program and connect to the unit.
Set the Unit ID and set a passcode using the Front Panel.
See Unit ID on page 6-4 and Set Passcode on page 6-2
for details.
Set the control port rate to the same setting as the PC
Com port.
Connect the PC Com port to the Chain-In port on the
ESU 120e using the DB25 adapter and modular cable
provided.
Follow the installation instructions for T-Watch PRO to
start the program and connect to the unit.
ESU 120e User Manual
Chapter 3. O peration
Action
Action
3-9
Advertisement
Table of Contents
