Table of Contents
Advertisement
A ppendix C. System Messages
Status Messages
Network Interface (NI)
Payload On
Line On
Loopback Off
Factory Restore Factory setting restored
Power On
Self-Test
Nx56/ 64 Interface
The following messages indicate the status of the Nx56/64 card:
Loop Up
Remote Loop Up Sending V.54 pattern in an attempt to loop up a
511 Pattern On
Loop Down
511 Pattern Off
D rop (PBX) Interface
The following messages indicate the status of the Drop interface:
Frame Slip
Line Loop Up
Port Loop Up
Loopdown
C-4
Payload loopback activated
Loopback off
All loopbacks deactivated
Unit powered on
Internal self-test performed
Data is looped at both the network interface
and DTE interface of the card
remote device
Sending 511 pattern towards the network
interface
Data is no longer looped back at the network
interface or DTE interface
No longer sending 511 pattern towards the
network interface
Indicates a Frame Slip has occurred on the Drop
interface; this is present in Alarm History only
Line loopback activated
Port loopback activated
Loopback has been deactivated
ESU 120e User Manual
1200420L1-1
Advertisement
Table of Contents
