Table of Contents
Advertisement
Unit Menu
The Unit menu changes the baud rate of the Control In port and the
setup of the Dial Out port. The menu items are:
Menu Item
Ctl Port
Traps
Access
Init Modem
Exit Term Mode Takes the unit out of terminal mode.
IP Interface
IP Address
61200420L1-1
Sets the baud rate for communication with the PC or
modem.
Choices: 1200, 2400, 9200, 9600, and 38400 kbps
Enables or disables the transmission of trap
messages.
Choices: Enable and Disable
Sets the method of connection from the ESU 120e to
T-Watch/SNMP.
Choices:
Direct - Used if connected directly to the PC.
Dial - Used when connection is through a modem.
The dial string is entered from T-Watch/SNMP.
Allows you to choose an industry standard or a
custom initialization string for a modem connected
to the control port.
Choices: Industry standard and Custom
Initialization String
Selects the TCP/IP physical interface; 10-Base-T
Ethernet or SLIP using the EIA-232 serial port.
Choices: 10-Base-T Ethernet or SLIP
If this option is set to SLIP, the EIA-232 port
may not be used as a terminal interface.
This is the IP address that uniquely identifies the
ESU 120e on a TCP/IP network. This address is
composed of four decimal numbers, each in the
range of 0 to 255, separated by periods. This value is
used for either the 10BaseT Ethernet or SLIP
interface, depending on the IP interface setting
ESU 120e User Manual
Chapter 5. Configuration Menu
Description
5-11
Advertisement
Table of Contents
