Condensed Water; Electrical Installation - Asko T793 Operating Instructions Manual

Installation

Condensed water

The machine is supplied as shown in Option
1 (inset). This means that the condensed
water is pumped into the condensed water
container. This must then be removed and
emptied by hand.
Option 2 allows you to remove the small short
hose from the nipple. Attach the rubber hose
supplied to the same nipple. The water can
then be pumped out into a sink or a floor drain
(2a).
2
1
2a
26

Electrical installation

The machine must only be connected to an
earthed wall socket.
Connection on delivery
The machine is supplied as 1-fas, 230V, with
a heat output of1950W and a 10A fuse. Any
earth fault fuses must be type A.
Switch-over
It is possible to switch over from 10A (heat
output 1950W) to 16A (heat output 2500W).
1. Shut off the power
2. Press and hold the Start button, and switch
on the power
3. Press the button in the centre of the
Max 1000 mm
program selector 5 times in 10 seconds.
Turn the program selector clockwise, so
that "Heater 2 off" appears in the display.
4. Press the button in the centre of the
program selector once to save the setting.
The machine returns to the program menu.
If you want to reset the machine to a 10A
connection:
1. Repeat steps 1-4.
2. During step 3 turn the program selector
until "Heater 2 off" appears on the display.
3. Press the Start button to store the setting.
The machine now has 10A connection.