Troubleshooting; The Machine Will Not Start; Overheating Cut-Out; Drying Takes Too Long - Asko T793 Operating Instructions Manual

Troubleshooting

The machine will not start

Check
• that the door is properly closed.
• that the main power switch is on.
• that the Delayed Start option has not been
selected. If so, the time remaining until the
start will be shown in full hours in the
display (e.g. 5, 4, 3h). To cancel Delayed
Start, press the Start/Stop button for 3
seconds.
• that the machine is not programd to start
at a specific time (e.g. 13.30)
• that the plug is connected.
• that the fuses (circuit breakers) in your
house are intact. Swap two circuit breakers
over to make sure. You cannot always tell
from the outside if a circuit breaker is
broken.
• that the overheating cut-out has not been
triggered (see below).

Overheating cut-out

The overheating cut-out shuts off the tumble
dryer if the temperature is too high, e.g.
because dust is clogging the lint filter.
• Clean the filter.
• Check also that the condensed water
container is not full and, if necessary, clean
the condenser. See the "Care and
cleaning" chapter.
• The overheating cut-out will reset
automatically once the machine has cooled
down.

Drying takes too long

• Empty the condensed water container and
check that neither the lint filter nor the
condenser is clogged. See the chapter
"Care and cleaning".
• Prolonged drying times may also be due
to the tumble dryer being located in a room
that is too small and the air in the room
(cooling air) being too hot.
• Make sure that the tumble dryer has
access to more cold air, e.g. by opening
doors and/or windows.
The washing does not dry, or is too
dry
• The door has been opened while the
program is running, which disrupts the
moisture monitoring function.

Error messages

• If "Over Flow" is shown in the display, the
condensed water container is full. Empty
the container and restart the program.
• If "Max program time" appears on the
display, the maximum program time has
been reached. See the "Troubleshooting"
chapter.
• If "Clean lint filter" appears on the display,
clean the lint filter.
21