Drying Program Finished; Once Drying Has Finished - Asko T793 Operating Instructions Manual

Tumble drying

Drying program finished

6
The text "END" appears in the display
when the program has finished. If the
Anti crease option has been selected, the
drum will rotate every minute for 2 hours after
cooling.
Important!
• Clean the lint filter after each load.
• Empty the condensed water
container after each load.
Caution!
If the lint filter becomes clogged, the
machine's automatic overheating cut-out may
be triggered. In order to be able to restart the
machine, you must clean the filter and allow
the machine to cool down for around 30
minutes.
Cleaning the lint filter
1. Grasp the filter handle and pull it towards
you.
2. Pull the filter out of its holder.
3. Open the filter and remove the lint by hand.
4. Fold the filter up and re-insert it into its
holder. The filter may need to be cleaned if it
has limescale deposits. See the "Care and
cleaning" chapter.
14
Emptying the condensed water container
The condensed water container must be
drained after each load. Remove the
condensed water container, empty out the
water and replace the container. If the
condensed water container becomes too full,
the program is interrupted and "Over Flow
fault" appears on the display. Empty the
container and press the Start button to restart
the program. See also the "Troubleshooting"
chapter.
Note!
Do not remove the condensed water
container while the machine is running.
Tip!
As the condensed water is decalcified, it can
be used in steam irons. Pour it through a
coffee filter.
Automatic emptying
If you want the water to empty automatically,
see the "Installation" chapter.

Once drying has finished

7
Turn off the main power switch. Remove
the clothes and close the door to
prevent small children from climbing into the
machine.