M.2 Ssd Module; Installing The M.2 Ssd Module - Dell EMC PowerEdge R440 Installation And Service Manual

Figure 73. Installing PERC card into internal PERC riser
Next steps
1. Install the internal PERC riser.
2. Install the air shroud.
3. Follow the procedure listed in

M.2 SSD module

NOTE: The write-protect switch is on the IDSDM or vFlash module.

Installing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in
2. Remove the air shroud.
3. Remove the BOSS card.
NOTE: The procedure to remove the BOSS card is similar to the
Steps
1. Connect the M.2 SSD module to the connector on the BOSS card.
2. Place the retention strap on the M.2 SSD module, and tighten the screw to secure the module.
After working inside your system
Safety instructions
on page 26.
on page 25
removing an expansion
Installing and removing system components
card.
79