Lom Riser Card; Removing The Lom Riser Card - Dell EMC PowerEdge R440 Installation And Service Manual

Figure 79. Installing optional IDSDM/vFlash card
Next steps
1. Install the MicroSD cards.
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2. Follow the procedure listed in

LOM riser card

Removing the LOM riser card

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If installed, remove the risers.
Steps
1. Using a Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the system board.
2. Release the two blue side plastic snaps holding the LOM riser card.
3. Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
4. Slide the LOM riser card towards the front of the system until the Ethernet connectors or the Small form-factor pluggable
(SFP) are clear of the slot in the back of the system.
After working inside your system
Safety instructions.
Before working inside your system
on page 26 .
on page 26.
Installing and removing system components 85