Power Interposer Board; Removing Power Interposer Board; Installing Power Interposer Board - Dell EMC PowerEdge R440 Installation And Service Manual

Power interposer board

Removing power interposer board

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud
4. Disconnect all the cables connected from the PIB to the system board.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board.
5. Remove the PSU.
Steps
1. Using a Phillips #2 screwdriver, remove the two screws securing the Power Interposer Board (PIB) to the system.
2. Lift the board and slide it out at an angle to disengage the guide pins on the board.
Figure 104. Removing power interposer board
3. Lift the board away for the system.
Next steps
1. Install the power interposer board.

Installing power interposer board

Prerequisites
Follow the safety guidelines listed in
Steps
1. Align the slots on the PIB with the guides on the system.
2. Using a Phillips #2 screwdriver, replace the two screws to secure the PIB to the system.
3. Route the cables and connect it to the system board.
102 Installing and removing system components
Safety instructions.
Before working inside your system
Safety instructions.
on page 26.