Removing An Expansion Card Riser - Dell EMC PowerEdge R440 Installation And Service Manual

Figure 56. Installing an expansion card riser 2
Next steps
1. Follow the procedure listed in
2. Install any device drivers required for the card as described in the documentation for the card.

Removing an expansion card riser

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Disconnect any cables connected to the expansion card.
Steps
Hold the touch points, and lift the expansion card riser, from the riser connector, on the system board.
Figure 57. Removing an expansion card riser 1A
After working inside your system
Safety instructions.
Before working inside your
on page 26.
system.
Installing and removing system components 69