Removing The Right Control Panel - Dell EMC PowerEdge R440 Installation And Service Manual

Figure 108. Installing the cable cover
Next steps
1. Follow the safety guidelines listed in
2. Install the air shroud.
3. Install the internal PERC riser.
4. Follow the procedure listed in

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the internal PERC riser.
Steps
1. Lift the cable latch and disconnect the control panel cable from the connector on the system board.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
2. Using a Phillips #1 screwdriver, remove the screws that secure the cable cover to the system.
Figure 109. Removing the cable cover
3. Using a Phillips #1 screwdriver, remove the screw that secures the control panel to the system.
Safety instructions.
Before working inside your system
Safety instructions.
Before working inside your system
on page 26.
on page 26.
Installing and removing system components 105