Step 3: Upgrading The Internal Exm Memory Module - AMX NetLinx NXP-TPI/4 Operation/Reference Manual

Input card
connectors
Extended memory
FIG. 6 Location of the memory modules

Step 3: Upgrading the internal EXM memory module

1. With the housing removed, locate the EXM memory module on the main board. Refer to FIG. 6 for
location information.
2. Discharge any static electricity from your body by touching a grounded metal object or the
grounding bolt shown in FIG. 4 on page 9.
3. Firmly grip the metallic braces (located on each side of the memory module) and pull them both
outwards until the previous module pops-up.
Alignment
groove
Metallic
braces
FIG. 7 Removing the memory module
4. Firmly grasp the existing memory module and pull it out at a 45° angle away from the connector
location on the main board.
5. Remove the memory module upgrade from the anti-static bag.
6. Firmly grasp the new memory module (from the edges) and insert the pins (at a 45° angle) into the
opening on the connector.
NXP-TPI/4 NetLinx Touch Panel Interface
module
Pull tabs outward
Module flips upwards
Compact Flash card
Housing screws
Connector
Pull memory
out at a 45° angle
Installation
Battery
EMI gasket
location
11