AMX NetLinx NXP-TPI/4 Operation/Reference Manual page 30

Installation
1. Discharge any acquired static electricity by touching a grounded metal object or by touching the
grounded bolt attached to the rear of TPI/4 unit.
2. Disconnect any incoming power connector from the rear of the TPI/4.
3. Connect either a PS/2 or USB mouse to the rear of the TPI/4 unit (as seen in FIG. 13).
4. Connect a USB cable from a rear USB connector port (on the computer) to the Type-B USB host
port input connector on the TP4-RGB card
5. Connect a HD-15 cable from the rear video port (on the computer) to the VGA/RGB 15-pin male
HD-15 RGB input connector on the TP4-RGB card.
6. Connect a DB9 touch input cable from the touch panel to the DB9 TOUCH INPUT connector on
the rear of the TPI/4 unit.
7. Connect the touch panels' HD-15 video cable to the VGA OUTPUT port on the rear of the TPI/4.
8. Cycle power to the unit. This cycling allows the unit to detect the new configuration.
9. Code a button on the touch panel page to enable the pass-thru feature on a selected input card slot.
Refer to the ^MPS section on page 122 for the specific command parameters to enable the Mouse
Pass-thru command on the RGB card. Toggling this coded panel button can enable/disable the
pass-thru feature.
The TPI/4 must first be set to match the resolution of the touch panels' video output
resolution (page 28), then select a Touch Driver (page 29). The video should
automatically fill-in the available screen area on the touch panel. There could be a
case where the image being generated from the TPI/4 is slightly "off" and should be
adjusted using the panel's on-board video adjustment buttons.
10. Setup the TPI/4 output resolution using the procedures in the Step 1: Setting the Output Resolution
on the TPI/4 section on page 28.
If the TPI/4 is turned Off and then has power re-applied (power cycling), video
alignment settings done through the Video and/or RGB pages could be rest unless
the adjusted values have been previously saved. Refer to the Video Adjustment -
Video Adjustment section on page 63 for more information.
11. Setup the touch drivers for the connected touch panel by using the procedures in the Step 2: Setting
the Touch Drivers section on page 29.
12. If necessary, use the panel's video adjust buttons to align the incoming video signal to fit into the
available screen area. Initially positioning the TPI/4 incoming video can reduce any later
adjustments of the video through the RGB Setup page (H-position, V-position, H-size, etc.).
24
.
NXP-TPI/4 NetLinx Touch Panel Interface