AMX NetLinx NXP-TPI/4 Operation/Reference Manual page 59

FIG. 38 Send to NetLinx Device dialog (showing NXA-BASE/B firmware update via IP)
The firmware for the input card can not be downloaded directly. Download of the KIT
file to the cards is done through the TPI/4. The procedures for updating firmware to
the cards is nearly identical to those for updating TPI/4 firmware, except that the KIT
file selected must be that of the particular card(s).
10. Click the Reboot Device checkbox. This causes the TPI/4 to reboot after the firmware update
process is complete. The reboot of the unit can take up 30 seconds after the firmware process has
finished.
11. Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the
dialog.
12. Click Close on the Send to NetLinx dialog window (after the TPI/4 reboots) to return to the main
program.
13. Right-click the associated System number and select Refresh System. This causes a refresh of all
project systems, establishes a new connection to the Master, and populates the System list with
devices on your particular system.
14. Press the front panel SETUP button (on the TPI/4) to navigate to the Setup page.
15. Confirm the current firmware version on the cards by pressing the Video Adjustment button and
then the corresponding Slot # button of the target TP4 card.
NXP-TPI/4 NetLinx Touch Panel Interface
Selected Battery Base Firmware file
Upgrading TPI/4 Firmware
Description field for selected KIT file
Firmware download
status
Device value and System number
must match the values
listed in the Workspace window
53