Vga Port: Connections And Wiring; Using The Vga Out Hd-15 High-Density Connector - AMX NetLinx NXP-TPI/4 Operation/Reference Manual

Installation
The following table lists the DB9 connector pinouts.
DB9 (female to female) Null Modem Pinouts
DB9 A Signal
Receive Data (RXD)
Transmit Data (TXD)
Data Terminal Ready
(DTR)
System Ground (GND) 5
Data Set Ready (DSR)
+ Carrier Detect
Request to Send (RTS) 7
Clear to Send (CTS)

VGA Port: Connections and Wiring

Using the VGA OUT HD-15 high-density connector

Connect the VGA source equipment HD-15 (male) connector (from the touch device) to the
VGA OUT HD-15 high-density connector (female) on the rear panel of the TPI/4. The following table
below lists the VGA OUT HD-15 connector pinouts.
VGA IN HD-15 Connector Pinouts
Pin Signal
1 Red
2 Green
3 Blue
4 N/A
5 GND
6 RAGND Red analog ground
7 GAGND Green analog ground
8 BAGND Blue analog ground
9 N/A
10 SAGND Synchronization analog ground
11 N/A
12 N/A
13 HSYNC
14 VSYNC
15 N/A
18
DB9 A DB9 B DB9 B Signal
2 3 TXD
3 2 RXD
4 6 + 1 DSR + Carrier Detect
5 GND
6 +1 4 DTR
8 CTS
8 7 RTS
Function
Red signals
Green signals
Blue signals
Not used
Signal Ground
Not used
Not used
Not used
Horizontal synchronization signal
Vertical synchronization signal
Not used
DB9 female
connector
side A
DB9 female
connector
side B
10
5
15
1 11
6
VGA HD-15 (male)
connector
NXP-TPI/4 NetLinx Touch Panel Interface
5 1
9 6
5 1
9
6