Misuse Of Equipment - York MILLENNIUM YCAS Installation Operation & Maintenance

• Correct utilization of the machinery in accordance
with the procedures detailed in the manuals.
ABOUT THIS MANUAL
The following terms are used in this document to alert
the reader to areas of potential hazard.
A WARNING is given in this docu-
ment to identify a hazard which could
lead to personal injury. Usually an in-
struction will be given, together with
a brief explanation and the possible re-
sult of ignoring the instruction.
A CAUTION identifies a hazard which
could lead to damage to the machine,
damage to other equipment and/or en-
vironmental pollution. Usually an in-
struction will be given, together with
a brief explanation and the possible
result of ignoring the instruction.
A NOTE is used to highlight additional
information which may be helpful to
you, but where there are no special
safety implications.
The contents of this manual include suggested best
working practices and procedures. These are issued for
guidance only, and they do not take precedence over
the above-stated individual responsibility and/or local
safety regulations.
This manual, and any other document supplied with the
unit, are the property of YORK which reserves all rights.
They may not be reproduced, in whole or in part, with-
out prior written authorization from an authorized YORK
representative.

MISUSE OF EQUIPMENT

Suitability for Application
The unit is intended for cooling water or glycol solutions
and is not suitable for purposes other than those speci-
fied in these instructions. Any use of the equipment other
than its intended use, or operation of the equipment con-
trary to the relevant procedures, may result in injury to
the operator or damage to the equipment.
YORK INTERNATIONAL
The unit must not be operated outside the design pa-
rameters specified in this manual.
Structural Support
Structural support of the unit must be provided as indi-
cated in these instructions. Failure to provide proper
support may result in injury to the operator, or damage
to the equipment and/or building.
Mechanical Strength
The unit is not designed to withstand loads or stresses
from adjacent equipment, pipework or structures. Ad-
ditional components must not be mounted on the unit.
Any such extraneous loads may cause structural failure
and may result in injury to the operator, or damage to
the equipment.
General Access
There are a number of areas and features which may
be a hazard and potentially cause injury when working
on the unit unless suitable safety precautions are taken.
It is important to ensure access to the unit is restricted
to suitably qualified persons who are familiar with the
potential hazards and precautions necessary for safe
operation and maintenance of equipment containing high
temperatures, pressures and voltages.
Pressure Systems
The unit contains refrigerant vapor and liquid under pres-
sure, release of which can be a danger and cause in-
jury. The user should ensure that care is taken during
installation, operation and maintenance to avoid dam-
age to the pressure system. No attempt should be made
to gain access to the component parts of the pressure
system other than by suitably trained and qualified
personnel.
Electrical
The unit must be grounded. No installation or mainte-
nance work should be attempted on the electrical equip-
ment without first switching OFF, isolating and locking-
off the power supply. Work on live equipment must only
be carried out by suitably trained and qualified person-
nel. No attempt should be made to gain access inside
the control panel or electrical enclosures during normal
operation of the unit.
FORM 201.18-NM2
1
9