Program Key; General - York MILLENNIUM YCAS Installation Operation & Maintenance

8.1 GENERAL

The Program key is used to program 12 system operat-
ing parameters including cutout points for safeties, an-
ticipatory unload points to avoid faults, and anti-recycle
timer duration.
When the Program key is pressed, the following mes-
sage will be displayed to indicate the display is in the
Program Mode:
P R O G R A M M O D E
Pressing the ENTER Key causes the display to show
the operator in what language the control panel mes-
sage are displayed.
D I S P L A Y
E N G L I S H
The operator may select 5 display message languages.
The options are English, Spanish, French, German and
á á á á á â â â â â
Italian. The or keys can be used to select the
desired language.
Pressing the Enter key repeatedly allows scrolling
through the programmable displays.
YORK INTERNATIONAL

8. PROGRAM KEY

L A N G U A G E
As each value is displayed, it may be reprogrammed
using the 12 Entry keys and
will be programmed into memory when the Enter key is
pressed and the display will scroll on to the next pro-
grammable value.
If an unacceptable value is entered at any stage, the
following message is displayed for a few seconds and
the entered value is ignored:
O U T O F R A N G E
T R Y A G A I N !
The following section shows examples of each program-
mable value display in the order in which they appear
after pressing the Program key, together with guidance
on programming each parameter.
The programmable values under the
Program Key must be checked and
properly programmed when commis-
sioning the chiller. Failure to prop-
erly program these values may cause
damage to the Chiller or operating
problems.
FORM 201.18-NM2
PROGRAM
KEY
29023A
áâ áâ
áâ áâ áâ
Keys. New values
135
9