Configuration Table 2 - American Dynamics TMV910Q User Manual

Configuration Table 2

Used to configure Alarm In & Motion Detect operation for Day/Night time frames.
The default values for the parameters in Configuration Table 2 are as follows:
Alm In Type
Motion Algr
Day: Alm In
Day: Motion
Night: Alm In
Night: Motion
A description of each parameter in Configuration Table 2 is presented in the table
below.
PARAMETER
Alarm in Type
Motion Algr
Day Alm In
Day Motion
Night Alm In
Night Motion
Advanced Setup Using On-Screen Menus
1 2 3 4 5
O O O O O
D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1
DESCRIPTION
Defines the signal type of the external alarm sensor as
Normally-Open (O) or Normally-Closed (C).
Select the motion detect algorithm for each camera:
D1=Normal (suitable to detect a small change in a large area
or for INDOOR usage), D2=Special (suitable to detect rapid
changes in a small area or for OUTDOOR usage); see also
Motion Detection on page 41 for motion detection set up.
Used to enable or disable each Alarm In pin during the Day
Frame, ( = enabled,
Used to enable or disable motion detection for each camera
during the Day Frame, ( = enabled,
Used to enable or disable each Alarm In pin during the
Night Frame, ( = enabled,
Used to enable or disable motion detection for each camera
during the Night Frame, ( = enabled,
Triplex Digital Video Multiplexer
6 7 8 9 10 11 12 13 14 15 16
O O O O O O
= disabled).
=disabled).
= disabled).
= disabled).
O O O O O
37