American Dynamics TMV910Q User Manual page 37

Use the Direction keys, the Enter key and the Camera Select keys to change the
values in the table.
PARAMETER
Camera Install
Covert
Termination Resistor
Gain Control
Rec Priority
Advanced Setup Using On-Screen Menus
DESCRIPTION
Used to manually disable channels to which there is no
camera or other input connected ( = camera installed,
• = no camera installed). When a channel is disabled, or
"un-installed", all related functions for that channel are
disabled in other setup menus, for example: video loss
detection, motion detection, etc. Disabled channels will
be skipped by the video encoder when encoding the
VCR Output signal, so that the remaining cameras are
recorded more frequently.
Allows chosen inputs to be made covert (invisible) on
both the Main Monitor and Call Monitor, while
continuing to be recorded by the VCR ( = camera
covert, • = camera noncovert).
Used to enable/disable the 75 Ω termination resistor
inside the multiplexer for each camera channel
( = termination resistor enabled, • = termination
resistor disabled). If the camera loop-back connector is
not in use, the termination resistor should be enabled for
correct signal termination; this is the default condition.
Used to set the video input gain for each camera. The
value ranges from 1 to 16 (70% to 150%).
Used to set the recording priority for each camera under
normal conditions (no alarm encountered). Cameras
with higher priority will be recorded more frequently by
the VCR. The value ranges from 1 to 16 (lowest to
highest priority). The Rec Priority of uninstalled cameras
will be set to 0 automatically.
Triplex Digital Video Multiplexer
29