Camera Auto-Detect; Camera Title - American Dynamics TMV910Q User Manual

User's Guide
PARAMETER
Alarm Rec Priority
Call Monitor Sequence

Camera Auto-Detect

The multiplexer can check the camera inputs for a video signal to determine whether
a functioning camera is connected or not. Auto detection avoids wasting VCR
recording bandwidth on undetected cameras. To use the auto detection function,
move the cursor to 2 Camera Auto-Detect, and press Enter. A table will appear, with
undetected cameras marked with a dot symbol in the corresponding position.

Camera Title

Camera titles can be turned on or off by configuring the OSD, or on-screen display
(see OSD on page 26). The default title for each camera is 1-16. This menu allows you
to enter a custom title (up to 12 characters) for each camera. In the Camera Set Up
Menu, move the cursor to 3 Camera Title and press Enter. The following list of
cameras will appear:
30
DESCRIPTION
Used to set the recording priority when an alarm is
triggered for the current channel, either by an Alarm In
or by Motion Detection. This value should be set above
the Rec Priority value for the channel if increased
recording detail is desired during an alarm.
There are 16 slots in the Call Monitor sequence. One
camera can be displayed in each slot, in sequence from
left (column 1) to right (column 16) in the row. Enter a
digit in each slot to customize the sequence: 0=jump to
next column, 1=channel 1, 2=channel 2, ... 16=channel
16.
Camera Title
1 Camera_1
2 Camera_2
3 Camera_3
4 Camera_4
5 Camera_5
6 Camera_6
7 Camera_7
8 Camera_8
9 Camera_9
10 Camera_10
11 Camera_11
12 Camera_12
13 Camera_13
14 Camera_14
15 Camera_15
16 Camera_16
17 Exit
Advanced Setup Using On-Screen Menus