Advertisement
Installation
Touch Tracker
•
The RS232-USB converter connects the RS232 DB9 port on the Touch Tracker's EIM and the USB port on the
DigiMux unit.
•
Domes connect directly to the Touch Tracker's EIM using Sensornet.
Setup and Configuration
•
The Touch Tracker is configured as MUX 16 POSEM. See the ADTT16E Touch Tracker Installation and Operation
Manual for instructions.
•
In the DigiMux OSD menu, select:
•
Keyboard: ADTT16
•
USB Port: front, rear-left, or rear-right. Rear port is recommended (save your front port for the USB flash
drive).
•
Dome protocol: set the dome protocol to AD422, and the Dome ID as set in the dome.
•
Reboot your DigiMux after the setup to allow the operating system to recognize the new device.
Operation Information
•
Dome control is available directly from the Touch Tracker.
•
The Touch Tracker can control the live display on the DigiMux main monitor.
•
Dome control is also available from:
•
DigiMux front panel,
•
Remote DigiClient, and
•
DigiRemote
Improved ControlCenter200/300 Keyboard Operation
The ControlCenter 200 and 300 keyboards' dome control capability is greatly improved with new software, firmware,
and a conversion kit. The new capabilities include Dome Configuration Menu access, QuickSets, and more.
Hardware Requirements
1. Your hardware version should be 0A5-10A60x04 or 0A6-10A60x04, where x can be 3 or 4.
2. An RS422/485 - RS232 converter. Use ADAC485CV232 or
•
Model ND-6520 by ADLINK technology, Inc., or other working model.
3. An RS232-USB converter (see Touch Tracker
Software Requirements
Install the new software provided with our USB flash drive, or download the software from the Internet. See the
DigiMux Software Update Instructions.
After the update, your DigiMux should have
DigiMux User's Manual Addendum
© 2005 Sensormatic Electronics Corporation
Dome
Sensornet
EIM
RS232-USB Converter
Hardware Version:
Software Version:
8200-0494-9900 A1
DigiMux
Hardware Requirements
0A5-10A60x04, or 0A6-10A60x04
1.0.6.20-16 (or newer)
on page 2).
3
Advertisement
