Installation Procedure; Configure The Camera - American Dynamics SpeedDome Ultra Drone III Installation Manual

Installation Procedure

Configure the Camera

To configure the camera, do either A or B:
A. Direct Cable (Pigtail) Configuration
Figure 2. Attaching the Dome Cables
Power
Connector
1. Connect the video coaxial-wire connector to
the camera dome (Figure 2).
2. Connect the three-wire power connector to the
camera dome (Figure 2).
Refer to Table 1 for the pinout arrangement of
the I/O board connector.
Table 1. I/O Board Connector (P8)
Pin Color
1 Black
2 Red
3 White
3. Attach the camera dome to the base. Refer to
Attach the Dome to the Base for instructions.
B. I/O Board Configuration
1. Ensure the I/O board is properly seated in the
dome base (Figure 3).
2. Attach the camera dome to the base. Refer to
Attach the Dome to the Base for instructions.
SPEEDDOME ULTRA DRONE III FIXED CAMERA
INSTALLATION GUIDE
Video
Connector
Designation
24Vac
Ground
24Vac
Figure 3. I/O Board Exploded View
Attach the Dome to the Base
1. Align the yellow alignment dot on the dome's
cap with the yellow arrow and alignment dot on
the base (Figure 4).
Figure 4. Attaching the Dome to the Base
Alignment
Tabs and
Dots
2. Mate the housing and eyeball assembly to the
base, and turn it counterclockwise until you
hear a click.
Note: This is a fixed camera; no communication
data lines are required.
Remove the Slot Cover
1. If necessary, tilt the eyeball to access the slot
cover containing the lens.
2. Unsnap the slot cover by gently tugging it away
from the eyeball (Figure 5 on page 3). You can
now access the camera set screw.
2 of 6
I/O Board
8200-0581-01, REV. A