American Dynamics SpeedDome Ultra Drone III Installation Manual page 3

Figure 5. Removing the Slot Cover and
Adjusting the Camera
Set Screw
Slot Cover
Adjust the Camera Settings
To make lens adjustments:
1. Loosen the set screw (Figure 5), and gently
pull the camera out until the screw reaches the
front end of the slot. Retighten the set screw.
2. Adjust the camera as follows:
a. Attach a hand-held video monitor to the
video cable entering the mounting base, or
have a second person view the remote
monitor while you adjust the camera.
b. Adjust the pan and tilt to point the camera
at a target, and then adjust the zoom and
focus, as desired.
c. Combine the zoom and focus ring
adjustments to achieve the desired view.
3. Loosen the set screw, and push the camera in
until the screw contacts the rear end of the slot
(Figure 6).
4. Retighten the set screw.
Figure 6. Repositioning the Camera
Set Screw
SPEEDDOME ULTRA DRONE III FIXED CAMERA
INSTALLATION GUIDE
Adjust the ADSDUDH-Series
Camera
If you are using an ADSDUDH-series camera,
adjust the camera as described in this section.
Note: Be sure to also follow the directions for
making the mechanical lens adjustments that are
described in the previous section, Adjust the
Camera Settings.
Figure 7. ADSDUDH-Series Camera
Zoom
Focus
Field of View
To adjust the ADSDUDH-series camera, make the
appropriate DIP switch settings:
• Low light mono mode (N.SVR / ON) – When
• Auto White Balance (AWB / AWB.EX)
• Line Lock (LL / INT)
• Flickerless Mode (FL / ON): When ON,
• Back Light Compensation (BLC) – When ON,
• Low Light Sensitivity (AGC-EX) – When set to
3 of 6
Focus
Adjuster
(Zoom)
Adjuster
ALC Adjustment
ON, the camera operates in monochrome mode
in reduced lighting.
− AWB: Camera operates in the normal Auto
White Balance range (2700K – 11000K)
− AWB.EX: Camera runs in the extended Auto
White Balance range (2000K – 18000K)
− LL: In this mode, V-Phase is adjusted to
compensate for connected power supply
differences
− INT: Camera operates with INTernal sync
camera reduces flicker in the image under
fluorescent lighting.
BLC improves the camera response to strong,
unwanted lighting effects behind the subject.
EX, sensitivity in low light is increased.
V-PHASE
Adjustment
DIP Switches
8200-0581-01, REV. A