Parts Lists; Declarations; Regulatory Compliance - American Dynamics SpeedDome Ultra Drone III Installation Manual

Parts Lists

Table 2. SpeedDome Ultra Drone III
No. Description
SpeedDome Ultra Drone III
—
2.5-6 mm NTSC
SpeedDome Ultra Drone III
—
3.8-9.5 mm NTSC
SpeedDome Ultra Drone III
—
9-22 mm NTSC
SpeedDome Ultra Drone III
—
2.5-6 mm PAL
SpeedDome Ultra Drone III
—
3.8-9.5 mm PAL
SpeedDome Ultra Drone III
—
9-22 mm PAL
1 Cover, Slot, w/o lens
2 Washer, FL, Type B, Reg,
SS, ¼"
3 Washer, LK, Split, Reg, Zn,
#14
4 Screw, ¼ x 20
5 Assembly, Bearing, Lens
Carriage, Drone
6 Bracket, Yoke
7 Tie, Cable, Nylon, 3.25
8 Bearing
9 Housing, Ultra Dome
10 Washer
11 Clip, Stop
12 Standoff, M3x33
13 Assembly, PCB
14 Cap
15 Label, Regulatory
16 Label, Certification
17 Base
18 Screw, M3x10
19 Screw, M3x6
20 Clip, Stress
21 Ring, Trim, Ultra
22 Cover, Slot, w/Lens Assy
23 Assembly, Bearing, Lens
Carriage, Drone
24 Yoke, Ultra Dome
25 Camera, w/Cable Assy
26 Assembly, Bearing, Lens
Carriage, Drone
* Note: Contact your technical support representative for
information on this part.
SPEEDDOME ULTRA DRONE III FIXED CAMERA
INSTALLATION GUIDE
Qty Part Number
1 0101-0166-01
1 0101-0166-02
1 0101-0166-03
1 0101-0166-04
1 0101-0166-05
1 0101-0166-06
1 0500-8037-01
1 *
1 *
1 *
1 *
2 0500-8038-01
3 *
1 *
1 0500-7255-02
3 *
1 *
3 *
1 0312-2204-01
1 0505-1224-01
1 *
1 *
1 0500-7257-02
3 *
3 *
1 *
1 *
1 0404-0353-01
1 *
1 0500-7258-01
1 See Board
Cameras table
1 *
5 of 6
Table 3. Board Cameras
No. Description
— 2.5-6 mm NTSC
— 3.8-9.5 mm NTSC
— 9-22 mm NTSC
— 2.5-6 mm PAL
— 3.8-9.5 mm PAL
— 9-22 mm PAL

Declarations

Regulatory Compliance

EMC ...............................................47 CFR, Part 15
Safety......................................................... UL 1950
REGULATORY PRODUCT NAME:
REG ID/TYPE=VP SDU
FCC COMPLIANCE: This equipment complies with Part 15
of the FCC rules for intentional radiators and Class A digital
devices when installed and used in accordance with the
instruction manual. Following these rules provides reasonable
protection against harmful interference from equipment
operated in a commercial area. This equipment should not be
installed in a residential area as it can radiate radio frequency
energy that could interfere with radio communications, a
situation the user would have to fix at their own expense.
EQUIPMENT MODIFICATION CAUTION: Equipment
changes or modifications not expressly approved by
Sensormatic Electronics Corporation, the party responsible for
FCC compliance, could void the user's authority to operate the
equipment and could create a hazardous condition.
See "About the Product" on page 1.
WARRANTY DISCLAIMER: Sensormatic Electronics
Corporation makes no representation or warranty with respect
to the contents hereof and specifically disclaims any implied
warranties of merchantability or fitness for any particular
purpose.
NOTICE: The information in this manual was current when
published. The manufacturer reserves the right to revise and
improve its products. All specifications are therefore subject to
change without notice.
Qty Part Number
1 2003-0053-01
1 2003-0053-02
1 2003-0053-03
1 2003-0053-04
1 2003-0053-05
1 2003-0053-06
EN 300 330
EN 301 489
RSS 210
CSA C22.2 No 950
EN 60950-1
8200-0581-01, REV. A