Table of Contents
Advertisement
• A compatible 48 Vdc passive PoE injector conforming to
802.3at.
• A 48 Vdc power source equipped with an M12A connector.
When providing the power source for the Cisco FM4500 Mobi, remember
the following important points:
• Install the power source as close to the unit as possible to minimize
voltage drop. The maximum suggested distance is 165ft (50m).
Connecting power to the Cisco FM4500 Mobi
NOTE
For detailed comparative information on which Fluidmesh
hardware
through IEEE 802.3at or IEEE 802.3af power sources, or
through a DC IN power source, refer to
requirements" (page
DC IN, LAN1/POE and LAN2 ports
The Cisco FM4500 Mobi radio transceiver unit has three connector ports
(Figure 6 (page
Figure 6. Device connector ports
• The DC IN connection (left-most connector) is a 5-pin M12A port,
exclusively designed to accept passive 48 Vdc power.
• The LAN2 connection (middle connector) is an 8-pin M12X port,
exclusively designed to connect the unit to a local area network
(LAN) switch.
© 2021 Cisco and/or its affiliates. All rights reserved.
CAUTION
Do not connect any PoE injector conforming to
802.3af
to the unit.
Such injectors have a higher voltage variance than the
design specification of the unit allows for, and may
result in unreliable performance.
devices
are
157).
29)):
Hardware installation
capable
of
accepting
"Electrical power
Page 29 of 174
IEEE
IEEE
power
Advertisement
Table of Contents
