Table of Contents
Advertisement
3.
A colored icon will be shown to the right of the red MONITOR™
link. The icon shows a summary of the current mode and status
parameters:
• If the icon is red and reads Disabled, the FM Monitor
application has been disabled.
• If the icon is gray and reads On-Premises, the FM Monitor
application is enabled, but the device is not currently
connected to the FM Monitor server. A possibility is that the
FM Monitor server cannot be reached.
• If the icon is green and reads On-Premises, the FM
Monitor application is enabled and the device is connected
to the FM Monitor server.
4.
For more information on how to use the controls and configure
FM Monitor, refer to the Fluidmesh Radio Monitoring Dashboard
Configuration Manual.
7.5. General settings
7.5.1. The General Mode window
The General Mode window contains controls to monitor and/or change the
following settings:
• The unit's operational mode.
• The version of Prodigy currently being used by the unit.
• The unit's LAN parameters.
• If the local unit is in Bridge Mode, the Bridge ID of the remote unit to
which the local unit must be linked.
To change the General Mode settings, do the following steps:
•
Click the -general mode link under GENERAL SETTINGS in the
left-hand settings menu (below).
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Page 62 of 174
Advertisement
Table of Contents
