Basic Parameters In 900 Mhz Units (Sw Version 4.5); Table 3-4: Basic Parameters In 900 Mhz Aus - Alvarion BreezeACCESS II CX System Manual

Chapter 3 - Commissioning

Basic Parameters in 900 MHz Units (SW version 4.5)

NOTE
For compliance with FCC rules, the power input to the 900
should not exceed 23dBm. The Transmit Power Control should be set to 1 (delivering
24.5dBm power output) onl
at least, or when using an external Band-pass filter to comp
the filter. Such a filter may be required if the equipment is lo
transmitter using frequencies that are close to the frequencies used by the
BreezeACCESS equipmen t.

Table 3-4: Basic Parameters in 900 MHz AUs

Parameter
IP Address
Subnet Mask
Default Gateway Address
DHCP Options
Access to DHCP
ESSID
Operator ESSID Option
Operator ESSID
HDM Mode
Flexible Hopping Definition
Scrambling Mode
Manual Sequence Definition
Spanning Factor
3-10
y when using a l onger RF cable
Default Value Comment
10.0.0.1
255.0.0.0
0.0.0.0
Disable
From Ethernet Only
ESSID1
Enable
ESSID1
Disable
915 MHz According to the spectrum
analy
when the Scan Entire Band is
enabled.
Enhanced
App able only when
Scram
to Manual Scrambling.
1 Applicable only for Enhanced
Scram ling with 7 or more
frequencies.
Cell Extender System Manual
MHz antenna of the C X
with an attenuation of 1.5dB
ensate for the power l oss in
cated near a very str ong
sis survey. Not applicable
lic
bling Mode is config ured
b