Preparing The Power Cord; Figure 2-10: Preparing The Power Cord - Alvarion BreezeACCESS II CX System Manual

Preparing the Power Cord

CAUTION
Electric Shock Hazard. The power plug should be connected only by a licensed
electrician.
The power cord should be environmentally protected with a ½ inch
conduit to the electrical junction box or breaker panel. If connecting to
a standard AC receptacle is required, attach a power plug that meets
local electrical regulations.
NOTE
The color codes of the power cable are as follows:
Black
Grey/White
Yellow/Green
To prepare the power cord:
1. Release the domed sealing nut and the special clip of the pow
protective connector.
2. Push the ½ inch conduit over the power cable and through the
domed sealing nut until it reaches the end of the special clip.
Continue pushing it onto the ferrule, and then tighten the domed
sealing nut.
Manual Revision 1.0
Phase ~
Neutral 0
Ground

Figure 2-10: Preparing the Power Cord

Installation Requirements
er cord
2-17