Installing the CX-IDU Interface Unit
The following sections describe how to install the Interface Unit,
including wall and poll mounting the unit, preparing the power cable
and connecting the ground and IF / Ethernet cables.
NOTE
The mechanical structure of current Interface Units of CX-BA2.4-BA2.4 and CX-BA2.4-
BA900 is sl
ightly different from the mechanical
Extenders as described throughout the manual. Refer to Appendix C for more details on the
applicable differences.
Ground Stud
NOTE
1. The unit is shown with all connectors installed, which is true for CX-BA2.4-BA2.4 and
CX-BA2.4-BA900. In system with a VL radio unit(s), blank cover(s) are installed in place
of the SU-IF and/or AU-IF connectors.
2. The unit is shown without the strings that secure the service boxes' bodies and top
nuts to the unit.
Manual Revision 1.0
Applicable to CX-BA2.4-BA2.4 and CX-BA2.4-BA900
structure of Interface Units of other Cell
Figure 2-6: Interface Unit Bottom Panel
Installation Requirements
2-13