Chapter 2 - Installation
Poll Mounting the Interface Unit
The Interface Unit must be installed with the bottom panel, which
includes the connectors, facing downward.
Special brackets and open-ended bolts are supplied with each unit.
There are two pairs of threaded holes on the back of the unit, enabling
the special brackets to be used for mounting the unit on up to 3" polls.
NOTE
Be sure to insert the open ended bolts with the grooves pointing outward, since these
grooves enable you to use a screwdriver to fasten the bolts to the unit.
If the unit is exposed to direct sunlight, the Sun Guard must be
installed to prevent overheating.
2-16
Figure
2-9: Pole Mounting the Indoor Unit
Cell Extender System Manual