Figure 3-1: Set Ip Window - Alvarion BreezeACCESS II CX System Manual

Chapter 3 - Commissioning
NOTE
If the Telnet session is not terminated properly, for example, if you simply close the
window, the monitor program is blocked for several minutes. To enable access to the
monitor program during that time, the unit must be reset via SNMP or by
disconnecting/reconnecting power.
Using the BreezeCONFIG to set an IP address:
The Set IP Address feature simplifies the procedure for defining IP
address information for newly added units that are still defined by the
defa ult IP settings. This feature can only
station is on the same Ethernet segment as the unit and not behind a
router.
1. In the toolbar, click
Set IP window is displayed, as shown below.
2. In the MAC Address field, enter the unit's MAC address.
3. In the IP Address field, enter the required IP address for the unit.
4. In the Subnet Mask field, enter the required subnet mask.
5. In the Default Gateway field, enter the unit's default gateway.
6. Click on
automatically.
3-4
be used if the management
, or select Set IP from the Tools m

Figure 3-1: Set IP Window

to activate the changes. The unit will be reset
Cell Extender System Manual
ir
enu. The