Figure 2-5: Breezeaccess Vl Odu Bottom Panel (Without The Service Box) - Alvarion BreezeACCESS II CX System Manual

To connect the indoor-to-outdoor Ethernet cable (VL units with an
installed service box):
1. Remove the two screws holding the service box to the outdoor unit
and remove the service box.
2. Unscrew the top nut from the service box.
3. Route a
through both the top
NOTE
The 8-wire cable should be shielded.
4. Insert and crimp the RJ-45 connector. Refer to
instructions on preparing the cable.
5. Connect the Ethernet cable to
6. Replace the service box and then the top nu
external jack of the cable is well inside the service box to guarantee
a good seal.
7. Route the cable to the location selected for the Interface Unit.
Manual Revision 1.0
Figure 2-5: BreezeACCESS VL ODU Bottom Panel
(without the service box)
straight, uncrimped Cat. 5 Ethernet cable (8-wire,
nut and the service box.
Installation Requirements
Appendix B
the outdoor unit RJ-45 connector.
t. Make sure that the
24 AWG)
for
2-11