Table of Contents
Advertisement
This manual introduces the BreezeACCESS Cell Extender and provides
a detailed description of the system components. In addition, this guide
describes how to install, initialize and operate the Cell Extender.
This guide is intended for technicians responsible for installing,
setting-up and operating the Cell Extender.
This guide comprises the following chapters:
Chapter 1– Introduction: Describes the Cell Extender and its
components.
Chapter 2 – Installation: Describes how to install Cell Extender
components.
Chapter 3 – Commissioning: Describes how to configure basic
parameters, align the Subscriber Unit antenna and validate unit
operation.
Appendix A - Wiring 10/100Base-T jacks: Describes standard
10/100Base-T wiring schemes.
Appendix B – Preparing the indoor to outdoor Ethernet cable:
Provides details on preparation of the indoor to outdoor Ethernet
cable.
Appendix C – CX-BA2.4-BA2.4 and CX-BA2.4-BA900 Mechanical
Structure of Interface Units: Describes the difference between
current mechanical design of the Interface Units of CX-BA2.4-BA2.4
and CX-BA2.4-BA900 and other Cell Extenders' Interface Units as
described in this manual.
This guide is applicable for BreezeACCESS II (2.4 GHz) and
BreezeACCESS 900 units running SW version 4.5, and for
BreezeACCESS VL units running SW version 2.0.
About this Guide
Advertisement
Table of Contents
