Adjusting Volume/Balance (Between Left And Right)/Fader (Between Front And Rear)/Defeat; Audio Mute Function; Blackout Mode On And Off; Changing The Audio Level Display Pattern - Alpine DVA-7996 Owner's Manual

Basic Operation
BAND
DN
DISP/B.OUT
CENTER f
UP
X-OVER
Adjusting Volume/Balance (Between
Left and Right)/Fader (Between Front
and Rear)/Defeat
1
Press the MODE (Rotary encoder) button repeatedly
to choose the desired mode.
Each press changes the modes as follows:
BALANCE
SUBWOOFER*
Volume : 0 ~ 35
Balance : L15 ~ R15
Fader: R15 ~ F15
Subwoofer: 0 ~ +15
NOTES
If the MODE button is not pressed within 5 seconds after
selecting the BALANCE, FADER, DEFEAT or SUBWOOFER
mode, the unit automatically returns to the VOLUME mode.
*When subwoofer mode is OFF or when LINK (rear DVD
function (page 34) is set to ON), its level cannot be adjusted.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting Defeat ON, previously adjusted settings of
BASS, TREBLE will return to the factory defaults, but
MX will be turned off.
NOTE
Depending on the connected devices, some functions and display
indications do not work.
8
-EN
MODE (Rotary encoder)
MUTE
FADER DEFEAT
VOLUME

Audio Mute Function

Activating this function will instantly lower the volume
level by 20 dB.
1
Press the MUTE button to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing the MUTE button again will bring the audio
back to its previous level.

Blackout Mode On and Off

When the Blackout mode is turned on, the display will
turn off to reduce power consumption.
This additional power enhances the sound quality.
1
Press and hold the B.OUT button for at least 3
seconds to start the blackout mode. By doing so the
display will turn off.
NOTE
If any button on the unit is pressed during the blackout mode, the
function will be displayed for 5 seconds to show the operation
before returning to Blackout mode.
To cancel the blackout mode, press and hold the
B.OUT button for at least 3 seconds.
Changing the Audio Level Display
Pattern
You can select the Audio Level Display from three
display patterns.
1
Press DISP button to switch the display pattern.
Pattern 1 Pattern 2 Pattern 3 OFF