Dvd/Video Cd Operation; Playing Dvd/Video Cd - Alpine DVA-7996 Owner's Manual

DVD/Video CD Operation

• DVD and video CD operations can be performed
from both the remote control unit and the main
unit (except for some operations). This section
mainly describes operations from the remote
control unit. For instructions on operating using
the buttons on the main unit, see page 42.
• A separately sold monitor is required to view
DVDs and video CDs.
• Play Position Memory Function:
Even if you turn power off or switch the Ignition
Key to OFF during playback or change the source,
playback will continue from the point where
playback stopped when the power is turned ON
again.
• When using the remote control unit
To operate a DVD or video CD, set the
Tips
selector switch on the rear of the remote
control unit to the "AUDIO" side.
• Reading this manual
Stopping playback (PRE-STOP)
Press the stop button during playback to stop
playback. That position is stored in the memory.
1
Press the button once during playback.
"PRE-STOP" is displayed.
SOURCE
These indicate the discs for
which the function can be used.
DVD
Video CD
..
.DVDs
DVD
...
Video CDs
Video CD

Playing DVD/Video CD

Caution • Not all functions will operate for every
DVD. See the individual DVD's
instructions for details on the features
supported.
• Fingerprints on a disc may adversely
affect playback. If a problem occurs,
remove the disc and check for
fingerprints on the playback side.
Clean the disc if necessary.
• When using the remote control, be
careful to press one button at time.
Pressing multiple buttons at the same
time may cause erroneous operation.
• If you switch the power or Ignition Key
OFF or change sources during playback,
playback will continue where you left off
when you resume playback.
• If you try to perform an invalid
operation (based on the type of disc
being played), the following mark is
displayed on the monitor screen:
1
Press the button on the main unit.
The movable display will open.
Insert a disc with the label side facing up.
2
Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically. The
movable display will close and playback will begin.
When a disc is already inserted, press the SOURCE
button to switch to the disc mode.
3
To eject the disc, press the
NOTES
If the disc does not eject, press an hold the
again for more than 3 seconds with the movable
display open.
The reverse side of a double-sided DVD will not be
played automatically.
Remove the disc, turn it over, and reinsert it.
DO NOT insert discs containing maps for the
navigation system. Doing so could result in damage.
"DISC ERROR" appears on the monitor display if a
non-compatible disc is loaded, if the disc is loaded
upside-down or if the disc is scratched or dirty. Press
the button on the main unit to open the display and
remove the disc.
DVD
Video CD
FR
ES
DE
IT
button on the main unit.
button
SE
Continued
29
-EN