Changing The Down Sampling Setting - Alpine DVA-7996 Owner's Manual

• Changing the rating level temporarily
Some discs may request that you
Tips
change the rating level set in the default
settings during playback. In this case,
the following message appears on the
monitor screen:
Still picture
Still Picture
If this screen appears, change the level
as follows:
• To change parental level and play,
press the ENTER button.
• To play without changing the
parental level, press the
(When the button is pressed,
playback will be at the parental level set
with "Setting Parental Lock." )
Changing the down sampling
setting
Some DVDs are recorded using a 24-bit/96 kHz
linear PCM (LPCM) signal. In order to play these
discs, the signal must be downsampled to 48
kHz/16 bit digital signals before being output
from the optical output.
NOTE
When the settings are changed, the old settings are
overwritten. Make a note of the current settings before
making changes. The settings are not cleared even when
the vehicle's battery is disconnected.
1
In the stop mode, press and hold the SETUP
button for at least 2 seconds.
The setup menu appears on the monitor screen.
NOTE
This operation cannot be performed in the PRE-STOP
mode. When the disc is being played, press the
twice to set the stop mode.
2
Use the Joystick to select "DOWN SAMPLING",
then press the ENTER button.
3
Move the Joystick up and down to choose "ON"
or "OFF" and, then press the ENTER button.
ON
The digital signals recorded on the DVD disc
with 96 kHz/24 bit, 96 kHz/20 bit, 96 kHz/16bit,
48 kHz/24 bit, 48 kHz/20 bit sampling are
converted into digital signals with 48 kHz/16 bit
sampling for output from the optical output.
Set to ON at time of shipment from factory.
OFF
Digital signals sampled at 96 kHz/24 bit, 96 kHz/
20 bit or 96 kHz/16 bit and recorded on the DVD
cannot be converted to 48 kHz/16 bit sampled
digital signal. There is no output from the optical
digital output terminal.
However, when CSS* scramble is on, a digital
signal sampled at 48 kHz/16 bit can be converted
button.
and sent out through the optical digital output.
NOTE
Press the RTN button to return to the previous screen.
4
Press and hold the SETUP button for at least 2
seconds.
The settings are stored and the set up mode is
canceled.
button
* CSS : An acronym for digital copy encryption
protection (Content Scrambling System).
FR
ES
DE
IT
SE
39
-EN