Use Of Tools - Bosch Opti MUM9 Series Instruction Manual

Recommended speeds
For folding in and mixing different
z
ingredients gently (e.g. folding in
beaten egg whites)
1-2 For stirring and mixing ingredients
3 For kneading heavy dough with the
kneading hook
5-7 For stirring and whipping ingredi-
ents (e.g. whipped cream) with the
professional flexible beating whisk
or the professional stirring whisk
Not suitable when using tools.
r
Re-adjustment of tools
The appliance is factory-set so the profes-
sional stirring whisk almost touches the
bottom of the bowl to ensure that ingre-
dients are mixed together perfectly. If the
tools touch the bottom of the bowl or are too
far from it, the gap can be easily corrected.
X "Re-adjustment of tools" see page 10
Swivel arm
X Fig. C
The swivel arm is moved up to
insert or to remove a tool or the bowl.
The swivel arm features an "EasyArm Lift"
function, which supports the upward move-
ment of the swivel arm.
Bowl and lid
X Fig. D
The appliance comes with a special bowl,
which is securely attached to the base unit
through insertion and rotation. The lid is
secured to the swivel arm and opens auto-
matically when the swivel arm is raised.
Inserting and removing tools
X Fig. E
The tools are equipped with eject buttons
on the protective cap which are used to
facilitate removal of the tools.
Insert tool: Insert the tool into the main
drive until it locks into place. The drive is
then covered by the protective cap.
Remove tool: Press both eject buttons
until the tool is released. Take the tool out
of the drive.
Cable storage
compartment
The appliance is equipped with a
cable storage compartment. The length of
the power cord can be adjusted as required
by pulling it out or pushing it back.
Safety systems
The appliance has various safety systems.
X "Safety systems" see page 11

Use of tools

W Risk of injury!
– Do not insert the mains plug until
all preparations for working with the
a ppliance are complete.
– While operating the appliance, never
reach into the bowl or filling shaft.
– Do not operate the appliance without
the lid in place.
– Always wait for the drive to come to a
standstill before moving the swivel arm
or changing tools.
– For safety reasons always fit the
p rotective drive covers on the front and
rear drive.
Preparation
■ Place the base unit on a smooth, clean
and stable surface.
■ Pull the power cord out to the required
length.
■ Press the release button and raise
the swivel arm to the stop.
■ Place the lid with the filling shaft at the
front on the main drive.
■ Insert the bowl. When doing so, use the
recesses on the base unit.
■ Turn the bowl anticlockwise until it locks
into place.
Important!
The appliance cannot be switched on
unless the bowl has been inserted correctly.
Use of tools en
7