Jonsered 6000+ Operator's Manual page 43

Checking the brake performance
The one-man sawmill must conform to local safety
requirements. Therefore, the performance of the
break must be checked once a week. Check the
brake as follows:
1. Start up the saw motor.
2. Increase the throttle (20) without activating the
brake handle (18).
3. The saw blade must not start.
4. If the saw blade begins moving, stop the saw
and do not use it until the brake mechanism
has been repaired. Get in touch with your local
dealer.
Saw blade height adjustment
To keep the saw blade height adjustment
mechanism in good working order, maintenance
on the following components is required.
Guide rails (22)
The guide rods that hold the saw unit in position
should be wiped off and coated with a thin film of oil,
whenever necessary.
Screws (6) and chain
The screws should be wiped off, whenever
necessary.
The drive chain, which unites the two height
adjustment screws should be oiled once a year.
To oil the chain, proceed as follows:
Turn the crank back and forth, about 20 turns in
each direction, and, at the same time, spray oil on
the chain. Use a cloth, or the like, to wipe off any
excess oil.
MAINTENANCE
6
22
20
18
43
English