Jonsered 6000+ Operator's Manual page 22

Scale
Mount the scale on the saw carriage as follows:
A. Back off the screws of the support (A) on the
upper beam of the saw carriage.
B. Insert the scale through the top of the
support and slide it downward. The highest
value marked on the scale should be at the
bottom end.
Secure the scale by means of screws on the
movable section of the blade carriage.
C. Place a level or other straight gauge block
over two of the rail cross-beams under the
saw carriage.
D. Measure the distance between the lower
section of the saw blade and the lower
section of the level or gauge block.
N.B! At this moment, the saw blade must be
tensioned and adjusted.
E. Preset the position of the support so that the
same value can be read on the scale at the
pointer.
F. Tighten the screws on the support.
22
English
INSTALLATION