Jonsered 6000+ Operator's Manual page 10

Carriage
The carriage consists of the following parts:
• Steel construction on wheels running on rails
and guide bars for raising and lowering the
saw.
• Two threaded rods for adjusting the height of
the saw. The rods are united by a chain and
are controlled by a crank equipped with a
pitch disc.
• Handle with controls
• Saw unit with the following components:
• • Motor.
• • Adjustable saw blade wheel.
• • Saw blade.
• • Moveable blade guide for optimal blade
control.
• • Petrol tank for petrol mixed with oil.
See "Handling fuel".
• • Tank for cleaning liquid for the saw blade.
• • Muffler.
Stand (7)
The carriage stand consists of square tubes
welded together and equipped with necessary
corner reinforcements which ensure stability
while sawing.
The stand is equipped with two round guide rods
for the upward and downward movement of the
saw. The guides transfer the transverse forces of
the saw to the stand.
The lower section of the stand has four groove-
rimmed wheels journalled in bearings for stability
and even movement along the rail.
To prevent the carriage from lifting off the rails, it
is equipped with two adjustable guide wheels
(bearings), which run along the underside of the
rails.
Height adjustment
The saw unit is stabilised vertically by two
interacting threaded rods (6). The threaded rods
are united by a chain for exact and simultaneous
movement.
A crank (1) is located on the top end of one of
the rods, and is used to set the exact lumber
thickness.
One turn of the crank moves the saw blade 5
mm. The saw blade height over the rail cross
beams can be read on the scale (5).
10
English
DESCRIPTION
5
1
6