Jonsered 6000+ Operator's Manual page 28

!
WARNING!
While using the saw, check to
make sure that the saw blade
does not come in contact with
the removable stops or the log
locking device.
!
WARNING!
The saw carriage must not be
moved backwards while the saw
blade is running. Otherwise the
blade may jump off its track and
cause injury.
6. Start the motor. See page 25.
7. Release the brake (18) and apply full throttle,
move the saw carriage forward and saw off
the slab. Do not advance the saw blade
harder than necessary. Allow the motor to
run at relatively high speed.
8. Remove the slab.
9. Release the log, rotate it through 180°, lower
the height adjustment device and lock the log
in position.
10. Reset the saw height required using the
height adjustment crank.
11. Set the band guide as close as possible to
the log without coming in contact with it. Use
the locking knob to lock the band guide in
position.
12. Saw off the other slab. See pages 6 and 7.
28
English
GENERAL USE
18