Jonsered 6000+ Operator's Manual page 40

!
WARNING!
Check that the grinding disc is
not cracked and that it is securely
mounted on the shaft. Stop the
grinding disc immediately if
abnormal vibrations arise.
!
WARNING!
Wear protective eye glasses while
grinding!
12. Fit the stop pin (Q).
13. Start up the grinding disc and the feeding
device by flipping the power switches (44 and
45) to the on position.
14. When the grinding unit stops automatically,
remove the stop pin.
15. Raise the grinding disc assembly with motor
and remove the saw blade.
To replace the grinding disc
!
WARNING!
Before replacing the grinding
disc, disconnect the power
supply to the grinding unit!
1. Raise the upper section of the grinding unit.
2. Hold the grindiing disc in place and use a
pair of tongs to loosen the nut (R).
3. Remove the worn grinding disc and fit the
new disc. Tighten nut (R) lightly using a pair
of tongs.
To mount the saw blade
Mount the saw blade on the one-man sawmill
according to the instructions on page 21.
40
English
MAINTENANCE
Q
45
44
R