Jonsered 6000+ Operator's Manual page 39

!
WARNING!
The risk that the grinding disc
may spin off and cause personal
injury.
Make sure that the power supply
is correctly wired so that the grin-
ding disc rotates in the right
direction, i.e. grinds downward
and backwards.
!
WARNING!
There is risk that the grinding
disc or the saw blade may be
dasmaged. This may lead to per-
sonal injury. The grinding disc
must not be in operation while
the procedure in items 8-11 below
are being carried out.
7. Start the feeding device by flipping the power
switch (44). The cam wheel (K) of the feeding
device must rotate counter-clockwise.
If it rotates in the wrong direction, transpose
the power cables.
8. Stop the feeding device and check where
the grinding wheel moves down against the
saw blade.
9. Adjust knob (L) until the grinding disc is exactly
tangent to the inner side of the saw tooth (M).
Repeat steps 7 and 8, if required.
10. Set the lifting device (N) in the apprpriate hole
in the lever (O) and start the feeding device.
Adjust knob (P) until the grinding wheel is
exactly tangent tothe entire gullet bottom during
feeding.
11. Stop the feeding device and turn both knobs
counter-clockwise 1/2 turn.
Note! Do not grind the saw blade too much as this
will impair its temper.
MAINTENANCE
P
N
O
L
K
M
44
45
39
English